Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Access Control Cost in Arvada?
Gate access control work in Arvada typically costs $185 to $420 per visit for diagnosis and repair of a keypad, loop detector, control board or safety sensor, while adding or replacing a complete access control setup on an existing automated gate usually runs $650 to $1,800 depending on wiring, entry points and operator compatibility. A full new access control system installed with the gate itself lands in the $2,400 to $6,500 range. The exact figure depends on the brand and components, and the written estimate after we inspect your gate sets the final price.
We work on the systems property managers here actually run: DoorKing and FAAC entry controllers on multi-unit properties, LiftMaster and Linear on residential gates, and Mighty Mule and Ghost Controls on smaller driveway entries. Electric gate repair is a specialty, not a side service, so the part that decides whether your gate opens isn’t something we guess at.
Key takeaways:
- Diagnosis and repair on most access control faults: $185 to $420.
- Replacing an entry keypad or card reader: $320 to $780 installed.
- Control board or panel replacement: $480 to $1,150.
- New access control setup on an existing gate: $650 to $1,800.
- Free estimates, and every price is set by the written estimate per job.
Gate Access Control Cost Breakdown (2026)
Access control is not one part. It’s the chain from the keypad or remote through the control board to the operator and the safety devices. Each link has its own price, and knowing which link failed is what keeps the bill honest. Here’s what Arvada pricing looks like for each piece in 2026.
| Work item | Typical price range |
|---|---|
| On-site diagnosis and access control repair | $185 – $420 |
| Entry keypad replacement (LiftMaster, Linear, DoorKing) | $320 – $780 |
| Card reader or telephone entry unit replacement | $450 – $1,100 |
| Control board or control panel replacement | $480 – $1,150 |
| Loop detector repair or replacement | $400 – $950 |
| Safety sensor replacement (photo-eye or edge sensor) | $185 – $400 |
| Operator motor or motor assembly replacement | $700 – $2,200 |
| New access control setup on an existing gate | $650 – $1,800 |
| Full new automated gate with access control installed | $2,400 – $6,500 |
Where the range falls depends on brand and duty class more than on anything else. A residential Mighty Mule or Ghost Controls keypad swap sits near the bottom. A DoorKing telephone entry unit on a multi-unit building with existing phone wiring sits near the top. Commercial-grade operators from FAAC, BFT, DoorKing and Viking take heavier control boards and sturdier housings, and those parts carry more cost than entry-level residential components. Wiring distance matters too: long buried runs to a keypad or reader can need reworking, and that pushes the number up.
Repair first is our default. If a control board has one failed relay and the rest of the panel is sound, we repair it rather than quote a full replacement. When a board is beyond saving, we say so and show you why.
What Affects Gate Access Control Pricing in Arvada
- The brand and its parts ecosystem. We’re fluent across nine brands, including LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite and Mighty Mule, and the parts for each sit at a different price. A Ghost Controls residential control board and a DoorKing commercial entry panel are not in the same category.
- Residential vs. commercial duty. A single-family gate in a neighborhood like Ralston Valley runs a light-duty operator. An HOA or apartment complex running a DoorKing or FAAC system needs boards and entry units built for constant traffic, and those cost more to replace.
- How many entry points you’re controlling. One driveway keypad is a different job from a vehicle reader plus a pedestrian gate reader plus a telephone entry panel for a gatehouse or shared building entrance.
- Wiring and burial on the property. If the control wiring to a keypad or detector is buried and needs a new run, the labor adds up. Where the existing wire is sound, the job stays simple.
- The Arvada climate. Cold snaps and freeze-thaw cycles work on gate hardware, and low temperatures strain moving parts and expand and contract soil around buried loops. Gates that bind in January often show up first as an access control fault when the operator fights the mechanism. Front Range hail and summer storms can take out photo-eye sensors and exposed keypads, which is one of the most common calls we get.
- The failure you’re starting from. A keypad with dead batteries is a quick fix. A control board that has lost communication with the operator, or a loop detector that reads a false presence, needs real diagnosis. The scope grows from there.
If you’re not sure where your gate’s problem sits, start with gate repair in Arvada and we’ll trace it from the operator to the control board. Our technicians have up to experience across residential and commercial gate platforms.
What Is Included in an Access Control Estimate?
An estimate covers a walk-through of the whole chain: the operator, the control board, the safety sensors, the access control devices, and the gate’s mechanical structure. We test each component and tell you which one failed, then write up what it takes to fix it and what the parts and labor will cost.
That matters because a lot of gates that look like an access control failure are actually a mechanical problem. A gate that has dropped on its hinges, or a slide gate that’s coming off track, will fight the operator, and the operator will register a fault. That’s the reason we don’t quote access control replacement before we’ve looked at the gate itself. From the motor to the control board, we diagnose the actual failure.
If you have an older operator you want to keep, we can tell you whether it will take a modern keypad or card reader. Some older FAAC and Viking units pair up cleanly with new controllers; others don’t, and we’d rather say so than sell you parts that won’t work. If you’re considering gate repair in Arvada on a gate that also needs a new operator, we’ll break the two apart on the estimate so you can see what each piece adds.
Access Control Repair vs. Replacement: Which Costs Less?
Repair usually costs less. A $185 to $420 diagnosis-and-repair visit on a failed keypad, sensor or relay is far cheaper than a $650 to $1,800 new access control setup. Replacement only makes sense when the control board is dead, the entry unit is no longer serviceable, or the system has outgrown the property (a new HOA gatehouse with more entries, for example).
We’d rather keep a working system working. If a board has a failed component we can trace, we fix that. If the whole board has given up and the part is available, we quote the board. Only when replacement is genuinely cheaper over the next few years do we recommend it, and we say why in plain terms.
How Much Does Commercial Gate Access Control Cost in Arvada?
Commercial gate access control usually runs higher. A DoorKing or FAAC entry system on an apartment building or HOA gatehouse typically lands in the $1,100 to $3,500 range for repair or a partial replacement, and full commercial access control installation can run $3,500 to $9,000 for a multi-entry setup with telephone entry units, card readers and loop detectors.
Commercial systems put more wear on the electronics. Multi-unit properties cycle their gates hundreds of times a day, and the access control panel was never designed for quiet residential duty. That means heavier boards, sturdier housings and more robust entry hardware. If you manage a property and you’re getting intermittent faults from a DoorKing or FAAC system, the problem is usually the control board or the loop detector, and a proper diagnosis saves you from replacing a whole panel that was fine.
How to Save on Gate Access Control in Arvada
The easiest way to save is to call when the problem starts, not after it’s had weeks to loosen bolts and bend hinges. A small sensor repair today can turn into an operator replacement later.
- Get a free estimate before authorizing work. We won’t start until you’ve seen the numbers and understood the scope. Call (844) 761-1390 and we’ll set one up.
- Ask for diagnosis before replacement. If your gate is opening but the reader isn’t reading, the fault is likely one component. Repair first, then replace only what’s failed.
- Keep the gate mechanically sound. A gate that swings or slides freely puts less strain on the operator and the control board. Annual greasing and bolt tightening prevent false faults.
- Stay with your existing brand. If you already run a LiftMaster or Linear operator, replacing one component keeps you on a system your technician knows well. Switching brands entirely rarely saves money.
- Bundle repairs on a single visit. If your keypad, sensor and loop detector all need attention, do them together. The estimate is free, so ask us to include everything you’ve noticed on one ticket.
Estimates are free, and every price is set per job by the written estimate. We answer 24/7 at (844) 761-1390, and dispatch runs 7am-7pm, Sunday through Friday.
What Happens When You Call Gate Repair Arvada
When you call, we ask a few questions: what brand your operator is, what the gate is doing (or not doing), and which access control device is giving you trouble. That lets us arrive knowing what to look at first. Then we diagnose the whole chain from the motor to the control board and the entry hardware.
If it’s a quick fix, we do it on the visit. If it needs a part, we’ll tell you exactly what’s coming and what it will cost before we order. If your gate is a mechanical problem, we’ll handle that too, because gate repair, electric gate repair and gate installation all sit with the same scope. Residential or commercial, manual or automated, the diagnosis and the estimate are where the work starts.
We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. We’re closed on Saturday.
FAQs – Gate Access Control Cost in Arvada
How much does a gate access control repair cost in Arvada?
Most access control repairs in Arvada run $185 to $420, covering diagnosis plus the fix on a keypad, sensor, relay or small board fault. Parts can push it higher, and the written estimate is the final number. Call (844) 761-1390 for a free estimate.
How much does a new keypad cost?
A new keypad installed typically runs $320 to $780, depending on the brand and whether new wiring is needed. LiftMaster and Linear units for residential gates sit in the lower half of that range. Commercial DoorKing entry units sit higher. Call us and we’ll price the exact model for your operator.
Can you replace just the control board, or do I need a whole new operator?
Usually just the control board. A board replacement typically costs $480 to $1,150, and that’s far cheaper than a new operator at $700 to $2,200. We diagnose first, and if the operator itself is sound, we’ll replace only the board. Call (844) 761-1390 to schedule a free estimate.
Is it cheaper to repair or replace access control on a commercial gate?
Repair is almost always cheaper. A commercial access control repair on a DoorKing or FAAC system typically runs $1,100 to $3,500, while a full commercial replacement can run $3,500 to $9,000. We diagnose the failure and recommend the cheaper path unless the system has genuinely failed. Call for a free on-site estimate.
Do you work on both residential and commercial access control systems?
Yes. We handle residential systems (LiftMaster, Linear, Mighty Mule, Ghost Controls) and commercial-grade systems (FAAC, BFT, DoorKing, Viking, Elite) from the same scope. Our technicians have up to experience across those platforms. Call (844) 761-1390 and we’ll confirm your brand before we arrive.
Can you come today?
Same-day service is often possible. Dispatch runs 7am-7pm, Sunday through Friday, and we’re closed Saturday. Call (844) 761-1390 and we’ll book the next opening. The estimate is free and the price is set per job.
Get a Free Access Control Estimate
Every gate access control job we price starts with a free estimate. We diagnose the whole system, explain which part failed, and write up what it will take to fix. No guessing, no pressure. Call Gate Repair Arvada at (844) 761-1390. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Your written estimate sets the final price.
Pricing reflects the Arvada market as of 2026. Gate Repair Arvada offers free estimates – call (844) 761-1390.
Written by the team at Gate Repair Arvada.
What Our Customers Say
"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
- Amanda Ziegler"Our slide gate had been dragging for months and getting worse. Turned out the chain was stretched and one of the guide rollers had seized. Both replaced, and he adjusted the limits so it stops properly at both ends now."
- Ebony Jackson"Gate works properly now and the price was fair. The one thing is that it took two visits, because the operator model we have is old and the part had to be ordered. They didn't charge for the second trip."
- Diego Herrera